Setup > Basic Setup - Cisco Linksys RE1000 User Manual

Linksys RE1000
Setup > Basic Setup
The first screen that appears is the Basic Setup screen This
allows you to change the Extender's general settings
Setup > Basic Setup
Language
Select your language
To use a different language, select
one from the drop-down menu The language of the
browser-based utility will change five seconds after you
select another language
Setup > Langages
Extender Address
Automatic Configuration - DHCP
The default Extender address Type is Automatic
Configuration - DHCP (Dynamic Host Configuration
Protocol) Keep the default if you connect using a dynamic
IP address (This option usually is the default setting s for
most devices )
Extender Address > Automatic Configuration - DHCP
Wireless-N Extender
Chapter 2: Advanced Configuration
Static IP
If you are required to use a fixed IP address to connect to
the upstream access point or router, select Static IP
Extender Address > Static IP
IP Address
This is the Extender's IP address as seen from
the upstream access point or router
Subnet Mask This is the router's subnet mask as seen
from the upstream access point or router
Default Gateway
This is the IP address of your upstream
AP or router
Upstream AP MAC address
This option is used when you want to select the upstream
access point or router that you want your Extender to
connect to Within a group of several access point or
routers all using the same SSID, you will force the Extender
to connect to a specific access point or router
Reboot
This option is used to reboot the device from within the
web UI Once Reboot is complete, you will be brought
back to the Basic Setup screen
4