Battery Removal - National Geographic NGDRONE2G Instruction Manual

Step 4
Plug the micro-USB end of the USB charging cable directly into the
battery charging port on the side of the drone. Then insert the USB end
of the charging cable into a USB power source (i.e. cell phone adapter).

BATTERY REMOVAL

BATTERY INSTALLATION AND CHARGING
Switch off power to the remote control and drone. Turn the drone over
on a flat and stable surface. Open the battery door and gently remove
the connected wires until they are outside of the battery compartment.
The battery can then slide out of the battery slot, and wires can be
disconnected.
DRONE OPERATIONS
BATTERY INSTALLATION AND CHARGING
WARNING! Drone flight is recommended in a spacious outdoor environment (such as a soccer field), at least 200
feet away from people, animals, and objects. DO NOT operate drone in unsafe conditions including wind, rain, or
snow. Even light wind can severely impact the ability to control and fly the drone, so it's always recommended to
avoid flying under these conditions.
Step 1
Confirm the battery is installed correctly and securely in battery compartment.
Turn on the drone by pushing the POWER button. The POWER button will
illuminate blue. Flashing lights on the bottom of the drone will indicate that
the drone has power and is waiting to be synced. Place the drone on the ground
a safe distance in front of you. The recommended distance is 10–15 feet.
Step 5
The POWER button will illuminate a red color indicating the drone is
charging. When fully charged the POWER button will no longer be
illuminated.
NOTE: POWER button must be in the off position or the drone will not
charge. The approximate charging time is 60–90 minutes.
LIGHTS LIGHTS
POWER