Drone Assembly - National Geographic NGDRONE2G Instruction Manual

CONTROLLER BATTERY INFO
BATTERY INSTALLATION AND CHARGING
Battery installation and removal should be performed by an adult.

Use only batteries recommended in this instruction manual.

Be careful to install the batteries with the correct polarity as indicated.

Do not mix old and new batteries.

Remove all batteries when replacing.

Do not mix alkaline, standard, rechargeable, or different types of batteries.

Non-rechargeable batteries are not to be recharged.

Rechargeable batteries are to be removed from the controller before being charged.

Rechargeable batteries are only to be charged under adult supervision.

Only batteries of the same or equivalent type as recommended are to be used.

The supply terminals are not to be short-circuited.

Remove exhausted batteries.

CAUTION: Do not dispose of battery in fire. Battery may explode or leak.

ions

DRONE ASSEMBLY

DRONE ASSEMBLY
FRONT
Step 1
Turn the quadcopter over on a flat surface so the bottom of the unit is facing
up. It is recommended that you place a towel or other cloth under the
quadcopter to protect it from getting scratched or scratching surfaces.
Step 2
Insert the landing struts into the bottom of the quadcopter. Struts should
align parallel to each other from front to back of the drone, leaving the
battery compartment unobstructed.
BACK
Step 3
Using the mini-screwdriver that was included with the kit, install 2 of the
10mm screws into the holes provided on the landing struts. Repeat this
process on the opposite side.
Step 4
Turn the quadcopter over so it is standing on its landing struts and install the
blade protectors on each corner. Blade protectors snap into place, and do
NOT require any screws.
NOTE: Blade protectors will help protect the propeller blades from being
damaged during contact with objects or surfaces. In the event a propeller is
damaged, it can be replaced with one of the 4 extra propeller blades supplied
with this kit. Blades are angled differently and numbered on the bottom
(Circled 1 or 2) and must be replaced with the same numbered blade.