Summary of Contents for National Geographic NGDRONE2G
Page 1
KNOW BEFORE YOU FLY KNOW BEFORE YOU FLY Before you take off, learn how to fly responsibly. Drone registration for this National Geographic Quadcopter Drone is not required as of June, 2016. Please check website for the most current rules and regulations:...
SAFETY PRECAUTIONS BATTERY INSTALLATION AND CHARGING Follow these safety precautions when operating this drone. Adult supervision required. Do not turn on the drone unless controller has been turned on first. Turn off controller and drone when not in use. ...
Do not put the loose cells in a pocket, bag, or drawer where they may short-circuit against other items or where the battery terminals could be pressed against each other. Never disassemble or modify pack wiring in any way or puncture cells. ...
CONTROLLER BATTERY INFO BATTERY INSTALLATION AND CHARGING Battery installation and removal should be performed by an adult. Use only batteries recommended in this instruction manual. Be careful to install the batteries with the correct polarity as indicated. Do not mix old and new batteries.
INSTALLING BATTERIES IN THE REMOTE INSTALLING BATTERIES IN THE REMOTE 4X 1.5V AA BATTERIES Remove the battery cover on the back of the remote control and install 4 x AA batteries (not included). Make sure to follow the diagram on the inside of the battery compartment to ensure that batteries are installed in the correct direction.
Step 4 Plug the micro-USB end of the USB charging cable directly into the battery charging port on the side of the drone. Then insert the USB end of the charging cable into a USB power source (i.e. cell phone adapter). Step 5 The POWER button will illuminate a red color indicating the drone is charging.
Page 7
Step 2 POWER To SYNC the drone start by standing DIRECTLY BEHIND the drone. Turn on the remote control by pushing the POWER button. The lights on the bottom of the drone will briefly flash, indicating the remote control is on and ready to sync. The SYNCED light on the remote control will also flash, confirming it’s ready to sync.
Page 8
Step 7 To turn the power OFF on the remote control, hold down the power button for approximately 1 second. The remote control has a built-in safety feature that requires the power button to be held down to power off. The remote control lights will turn off, indicating power has been deactivated.
Page 9
TRIM BATTERY INSTALLATION AND CHARGING The trim feature helps align the drone during flight and counter any drift, i.e. if it “pulls” in one direction when the controller is in the centered position. Each time you put in the battery the balance of the drone may be slightly affected by the exact battery position.
Page 10
CONTENTS BATTERY INSTALLATION AND CHARGING Extra batteries can be purchased at https://goo.gl/vK9dJP. Make sure to use ONLY authentic National Geographic Quadcopter Drone batteries. We do not recommend buying batteries from third party suppliers as they may not be suitable for safe operation as they could damage the drone or the USB charging device.
TROUBLESHOOTING BATTERY INSTALLATION AND CHARGING Problem Reason Solution The quadcopter lights are flashing 1. The sync between the remote and 1. Try re-syncing the remote to the but it is not responsive to the drone. You may need to move closer the drone is not complete.