Subscribe to Our Youtube Channel
Related Manuals for GreenWorks GC 400
Summary of Contents for GreenWorks GC 400
- Page 1 82V LITHIUM-ION BATTERY CHARGER GC 400 (2907302) Owner’s Manual TOLL-FREE HELPLINE: 1-855-470-4267 www.greenworkstools.com/82v-Commercial/ Read all safety rules and instructions carefully before operating this tool.
-
Page 2: Table Of Contents
Know Your Charger ......................6 Operation ..........................7 Maintenance ........................1 0 Troubleshooting........................11 Limited Warranty........................12 PRODUCT SPECIfICATIONS COMPONENTS SPECIFICATIONS Charger 82V Lithium-ion Battery Charger Model GC 400 Input 120V AC, 50/60Hz, 5A Output 82V DC, 4A Weight 3.3 lbs (1.5 kg) -
Page 3: Important Safety Instructions
CONNECTOR OR UNINSULATED BATTERY TERMINAL. • SAVE THESE INSTRUCTIONS - This manual contains important safety and operating instructions for battery charger GC 400. • Before using battery charger, read all instructions and cautionary markings on battery charger, battery, and product using battery. - Page 4 IMPORTANT SAfETY INSTRUCTIONS • Do not abuse cord or charger. Never use the cord to carry the charger. Do not pull the charger cord rather than the plug when disconnecting from receptacle. Damage to the cord or charger could occur and create an electric shock hazard. Replace damaged cords immediately. •...
-
Page 5: Symbols
SYMBOLS Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper interpretation of these symbols will allow you to operate the product better and safer. SYMBOL NAME DESIGNATION/EXPLANATION Volts Voltage Hertz frequency (cycles per second) Watts Power... -
Page 6: Know Your Charger
KNOW YOUR CHARGER The safe use of this product requires an understanding of the information on the product and in this operator’s manual as well as a knowledge of the project you are attempting. Before using this product, familiarize yourself with all operating features and safety rules. LED Light Electrical Contacts Cooling Air Port... -
Page 7: Operation
OPERATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. -
Page 8: Charging Procedure
OPERATION CHARGING PROCEDURE NOTE: The battery is not shipped fully charged. It is recommended to fully charge before first use to ensure that maximum run time can be achieved. This lithium-ion battery will not develop a memory and may be charged at any time. Low voltage charging: If the battery has been stored with little to no charge for a long period of time, the charger will go into recovery mode, which will take 20 hrs to fully charge the battery. - Page 9 OPERATION CHARGER MOUNTING 1. This charger can be installed hanging on a wall using two #8 screws (not included). 2. Locate the placement for the charger to be wall mounted. 3. If fastening to wood studs use 2 wood screws (not included). 4.
-
Page 10: Maintenance
MAINTENANCE W A R N I N G To avoid serious personal injury, always remove the battery pack from the tool when cleaning or performing any maintenance. W A R N I N G When servicing, use only identical GW replacement parts. Use of any other parts may create a hazard or cause product damage. -
Page 11: Troubleshooting
TROUBLESHOOTING PROBLEM CAUSE SOLUTION Charger doesn't work. Charger Battery pack or charger is 1. Try to remove and reinsert shows defective mode (LED defective or bad connection the battery pack in the charger. flashes Red). between the battery pack and 2. -
Page 12: Limited Warranty
(2) years against defects in materials, parts or workmanship. GREENWORKS™, at its own discretion will repair or replace any and all parts found to be defective, through normal use, free of charge to the customer. This warranty is valid only for units which have been used for personal use that have not been hired or rented for industrial/ commercial use, and that have been maintained in accordance with the instructions in the owners’... - Page 13 Transportation charges for the movement of any power equipment unit or attachment are the responsibility of the purchaser. It is the purchaser’s responsibility to pay transportation charges for any part submitted for replacement under this warranty unless such return is requested in writing by GREENWORKS.
- Page 14 Greenworks Tools P.O. Box 3130 Mooresville, North Carolina 28117 TOLL-FREE HELPLINE: 1-855-470-4267 Rev: 00 (11-16-15) Printed in China on 100% Recycled Paper...
Need help?
Do you have a question about the GC 400 and is the answer not in the manual?
Questions and answers