Table of Contents
Advertisement
Notice for Installers
The servicing instructions in this notice are for use by qualifi ed service personnel only. To reduce the risk of electric shock,
do not perform any servicing other than that contained in the operating instructions, unless you are qualifi ed to do so.
Note to System Installer
For this apparatus, the cable shield/screen shall be
grounded as close as practical to the point of entry of the
cable into the building.For products sold in the US and
Canada, this reminder is provided to call the system
installer's attention to Article 800-93 and Article
800-100 of the NEC (or Canadian Electrical Code Part
1), which provides guidelines for proper grounding of
the cable shield.
This symbol is intended to alert you that uninsulated
voltage within this product may have sufficient
magnitude to cause electric shock.Therefore, it is
dangerous to make any kind of contact with any inside
part of this product.
Ce symbole a pour but d'alerter toute personne qu'un
contact avec une pièce interne de ce produit, sous
tension et non isolée, pourrait être suffisant pour
provoquer un choc électrique. Il est donc dangereux
d'être en contact avec toute pièce interne de ce produit.
IMPORTANT SAFETY INSTRUCTIONS
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance with the manufacturer's instructions.
8) Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus
(including amplifi ers) that produce heat.
9) Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding-type plug has two blades and a third grounding
prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fi t
into your outlet, consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles,
and the point where they exit from the apparatus.
11) Only use attachments/accessories specifi ed by the manufacturer.
12)
Use only with the cart, stand, tripod, bracket, or table specifi ed by the manufacturer, or sold
with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination
to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualifi ed service personnel. Servicing is required when the apparatus has been
damaged in any way, such as a power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
Power Source Warning
A label on this product indicates the correct power source for this product. Operate this product only from an electrical
outlet with the voltage and frequency indicated on the product label. If you are uncertain of the type of power supply
to your home or business, consult your service provider or your local power company.
The AC inlet on the unit must remain accessible and operable at all times.
Ground the Product
WARNING: Avoid electric shock and fi re hazard! If this product connects to cable wiring, be sure
the cable system is grounded (earthed). Grounding provides some protection against voltage surges
and built-up static charges.
Protect the Product from Lightning
In addition to disconnecting the AC power from the wall outlet, disconnect the signal inputs.
Verify the Power Source from the On/Off Power Light
When the on/off power light is not illuminated, the apparatus may still be connected to the power source. The light
may go out when the apparatus is turned off , regardless of whether it is still plugged into an AC power source.
Eliminate AC Power/Mains Overloads
WARNING: Avoid electric shock and fi re hazard! Do not overload AC power/mains, outlets, extension
cords, or integral convenience receptacles. For products that require battery power or other power
sources to operate them, refer to the operating instructions for those products.
Provide Ventilation and Select a Location
• Remove all packaging material before applying power to the product.
• Do not place this apparatus on a bed, sofa, rug, or similar surface.
• Do not place this apparatus on an unstable surface.
• Do not place this apparatus in excessive heat or moisture.
• Do not install this apparatus in an enclosure, such as a bookcase or rack, unless the installation provides proper
ventilation.
• Do not place entertainment devices (such as VCRs or DVDs), lamps, books, vases with liquids, or other objects
on top of this product.
• Do not block ventilation openings.
Operating Environment
This product is designed for operation indoors with a temperature range from 32° to 104° F (0° to 40°C). Each
product should have adequate spacing on all sides so that the cooling air vents on the chassis are not blocked.
Protect from Exposure to Moisture and Foreign Objects
WARNING: Avoid electric shock and fi re hazard! Do not expose this product to dripping or splashing
liquids, rain, or moisture. Objects fi lled with liquids, such as vases, should not be placed on this apparatus.
WARNING: Avoid electric shock and fi re hazard! Unplug this product before cleaning. Do not use
a liquid cleaner or an aerosol cleaner. Do not use a magnetic/static cleaning device (dust remover) to
clean this product.
WARNING: Avoid electric shock and fi re hazard! Never push objects through the openings in this
product. Foreign objects can cause electrical shorts that can result in electric shock or fi re.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affi liates in the U.S. and other
countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks
mentioned are the property of their respective owners. The use of the word partner does not imply a partnership
relationship between Cisco and any other company. (1110R)
Manufactured under license from Dolby Laboratories. Dolby is a trademark of Dolby Laboratories.
The terms HDMI and HDMI High-Defi nition Multimedia Interface, and the HDMI Logo are
trademarks or registered trademarks of HDMI Licensing LLC in the United States and other countries.
Rovi is a trademark of Rovi Corporation.
The Wi-Fi Protected Setup mark is a mark of the Wi-Fi Alliance. Wi-Fi Protected Setup is a trademark of the Wi-Fi Alliance.
© 2014 Cisco and/or its affi liates. All rights reserved.
Printed in China PRC
CAUTION: To reduce the risk of electric shock, do not remove cover
(or back). No user-serviceable parts inside. Refer servicing to
qualified service personnel.
WARNING
TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
UNIT TO RAIN OR MOISTURE.
This symbol is intended to alert you of the presence of important
operating and maintenance (servicing) instructions in the literature
accompanying this product.
Ce symbole a pour but de vous avertir qu'une documentation
importante sur le fonctionnement et l'entretien accompagne ce produit.
Last Updated: July 2014
78-21653-01C0
Service Warnings
WARNING: Avoid electric shock! Do not open the cover of this product. Openingor removing the cover
may expose you to dangerous voltages. If you open the cover, your warranty will be void. This product contains
no user-serviceable parts.
Check Product Safety
Upon completion of any service or repairs to this product, the service technician must perform safety checks to
determine that this product is in proper operating condition.
Protect the Product When Moving It
Always disconnect the power source when moving the apparatus or connecting or disconnecting cables.
Compliance Information
United States FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifi cations not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
This device is going to operated in the 5.15-5.25 MHz frequency ranges, it is restricted in indoor
environment only
The availability of some specifi c channels and/or operational frequency bands are country dependent and are fi
rmware programmed at the factory to match the intended destination. The fi rmware setting is not accessible by the
end user.
Devices will not permit operations on channels 120-132 for 11a and 11n/a which overlap the 5600 - 5650 MHz band.
ITV7900 Family IP Set-Top
Models ITV7904, ITV7906, and ITV7908
Manufactured by: Cisco Systems, Inc.
170 West Tasman Drive
San Jose, CA 95134 USA
www.cisco.com/go/contacts
Note: The ITV7906 andITV7908 have disabled the 5600-5650M band by S/W to avoid 5600-5650M band for
IC certifi cation.
Canada EMI Regulation
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la class B est conforme à la norme NMB-003 du Canada.
AVC VIDEO LICENSE
With respect to each AVC/H.264 product, we are obligated to provide the following notice:
THIS PRODUCT IS LICENSED UNDER THE AVC PATENT PORTFOLIO LICENSE FOR THE PERSONAL USE OF
A CONSUMER OR OTHER USES IN WHICH IT DOES NOT RECEIVE REMUNERATION TO (i) ENCODE VIDEO IN
COMPLIANCE WITH THE AVC STANDARD ("AVC VIDEO") AND/OR (ii) DECODE AVC VIDEO THAT WAS ENCODED
BY A CONSUMER ENGAGED IN A PERSONAL ACTIVITY AND/OR WAS OBTAINED FROM A VIDEO PROVIDER
LICENSED TO PROVIDE AVC VIDEO. NO LICENSE IS GRANTED OR SHALL BE IMPLIED FOR ANY OTHER USE.
ADDITIONAL INFORMATION MAY BE OBTAINED FROM MPEG LA, L.L.C. SEE HTTP://WWW.MPEGLA.COM.
Accordingly, please be advised that service providers, content providers, and broadcasters may be required to
obtain a separate use license from MPEG LA prior to any use of AVC/H.264 encoders and/or decoders.
ROVI CORPORATION COPYRIGHT NOTICE
This product incorporates copyright protection technology that is protected by U.S. patents and other intellectual
property rights of Rovi Corporation. Use of this copyright protection technology must be authorized by Rovi Corporation,
and is intended for home and other limited viewing uses only unless otherwise authorized by Rovi Corporation. Reverse
engineering and disassembly are prohibited.
Disclaimer
Cisco Systems, Inc. assumes no responsibility for errors or omissions that may appear in this manual. We reserve the
right to change this manual at any time without notice.
IMPORTANT NOTE:
FCC RF Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator and your body.
This device and it's antennas(s) must not be co-located or operating in conjunction with any other antenna or transmitter
except in accordance with FCC multi-transmitter product procedures
Industry Canada Statement:
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Caution:
The device for the bands 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to
co-channel mobile satellite systems.
High power radars are allocated as primary users (meaning they have priority) of 5250-5350 MHz and 5650-5850
MHz and these radars could cause interference and/or damage to LE-LAN devices.
IMPORTANT NOTE:
Canada RF Exposure Statement:
This system has been evaluated for radiofrequency exposure for humans in reference to Canada Health Code 6
(2009) limits. The evaluation was based on evaluation per RSS-102 Rev 4. The minimum separation distance
from the antenna to general bystander is 7.9 inches (20cm) to maintain compliance.
L'exposition humaine aux radiofréquences émises par ce système a été évaluée conformément aux limites
spécifi ées dans le Code de sécurité 6 de Santé Canada (2009). Cette évaluation était basée sur l'évaluation
décrite dans le document RSS-102 Rev 4. Cette norme défi nit à 20 cm (7,9 po) la distance minimale devant
séparer l'antenne de toute personne.
FCC Declaration of Conformity
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions: 1) the
device may not cause harmful interference, and 2) the device must accept any interference received, including
interference that may cause undesired operation.
20110316_IP_No Tuner_Safety
20081121 FCC Standard
Advertisement
Table of Contents
