Table of Contents
Advertisement
EL552.256-Q2
Input signals VID
in Figure 4, pixel information is supplied from left to right and from top to bottom,
four pixels at a time. Video data for one row is latched on the fall of HS.
1,2,3,4
VID3
VID2
VID1
VID0
Figure 4. Pixel Location vs. Sequence of Data
Self-Test Mode
The display will enter the self-test mode if all seven video inputs (VCLK, HS, VS,
and VID0 through VID3) are high for longer then 2.5 seconds at power up. The
self-test scans at 100 Hz with a diagonal pattern that changes back and forth every
2.5 seconds from 3 pixels on/1 pixel off to 1 pixel on/3 pixels off.
After the self-test, turn the display off and wait at least 15 seconds before
reapplying power to allow the internal capacitors to completely discharge. When
you turn the display on again, apply video signals in less than 2.5 seconds after
power up to enter normal operation.
8
EL552.256-Q2 Operations Manual (OM410-00)
through VID
contain the video data for the screen. As shown
0
3
5,6,7,8
9,10,11,12
13,14,15,16
EL Panel
(Front)
1
5
2
6
10
3
7
4
8
9
13
14
15
11
12
16
549, 550, 551, 552
Row 1
549
550
551
552
Advertisement
Table of Contents
