Installing & Cleaning Foam Wet Filter; Troubleshooting - Vacmaster VJH1211PF 0201 Operator's Manual

INSTALLING & CLEANING FOAM WET FILTER
1 2
I n s t a l l i n g F o a m W e t F i l t e r
1. Verify that the power cord is disconnected from the outlet. (Fig.1)
2. Remove power head and place in upside down position. Follow instructions to remove
cartridge filter.
3. Carefully slide foam wet filter down over the filter cage making sure the cage is completely
covered. (Fig. 2 & 3)
4. Place the power head onto the collection tank.
C l e a n i n g F o a m W e t F i l t e r
1. With the removed power head in an upside down position, carefully remove foam wet filter. (Fig.
4)
2. Use a mild soap and water solution to wash foam wet filter and rinse with clean water. (Fig. 5)
3. Allow filter to air dry before installing and using again.
W A R N I N G : T O R E D U C E T H E R I S K O F E L E C T R I C S H O C K , U N P L U G
T R O U B L E S H O O T I N G .
S y m p t o m
Vacuum will not operate
Dust comes out from motor
cov e r.
Reduced efficiency and motor/
sp eed v i b ration.
3

TROUBLESHOOTING

P o s s i b l e C a u s e s
1) No power supply.
2) Faulty power cord.
3) Collection tank full.
1) The cartridge filter is missing
or damaged.
1) There is a blockage in the
nozzle, hose, or the collection
tank inlet. The cartridge filter is
clogged by fine dust.
4
C o r r e c t i v e A c t i o n
1) Check power supply – cord,
b reakers, fuses.
2) Unplug and check the power
cord.
rep aired b y a p rofessional.
3) Empty collection tank.
1) Attach or replace cartridge
filter.
1) Check nozzle, hose and
c o l l e c t i o n t a n k i n l e t s f o r
b lockage.
and clean it or install a new
cartridge filter.
1 2
5
B E F O R E
I f damaged, hav e it
Take off the filter