JVC KD-S785 Service Manual page 5

Removing the heat sink
1. Remove the three screws A on the left side of the
body.
Removing the bottom cover
Prior to performing the following procedure, remove
the front panel assembly, the front chassis assembly
and the heat sink.
1.
Turn the body upside down.
2. Insert a screwdriver to the two joints b and two joints
c on both sides of the body and the joint d on the
back of the body, then detach the bottom cover from
the body.
CAUTION: When disengaging the joint d using a
screwdriver, do not damage or break the
board.
(See Fig.4)
(See Fig.5, 6)
Heat sink
A
Fig.4
Joint b
Bottom cover
Joint d
Rear panel
Fig.5
Bottom cover
Joint b
Rear panel
Fig.6
KD-S785
A
Joint c
Joint c
Joint d
1-5