9 OPERATING INSTRUCTIONS
Connect polisher to the mains.
Hold safety switch (3) down whilst simultaneously pressing on/off button (3).
Set polisher to desired speed using speed selector (4).
Apply polishing cap to surface to be polished, and move polisher gently in a
figure-of-eight pattern.
Avoid pressing polisher hard against surface to be polished, but press a little
harder when polishing corners or angles.
Buff thoroughly to achieve the best possible final result. Lift polishing cap
from surface, and stop by
releasing on/off button.
10
TECHNICAL DATA
Model number
Nominal voltage
Power consumption
No load speed
Polishing disk
11
NOISE
Noise values measured according to relevant standard. (K = 3)
Acoustic pressure level L
Acoustic power level L
ATTENTION! The sound power level may exceed 85 dB(A), in
this case individual hearing protection shall be worn.
a
(Vibration)
w
Copyright © 2015
FE1-25
FE1-25
230-240V ~50Hz
1050W
1000-3000min
Ø150 mm
pA
wA
6.51 m/s²
P a g e
-1
www.Ford-tools.com
| 7
EN
84 dB(A)
95 dB(A)
K = 1.5 m/s²