Osd (On-Screen Display) Control Punch Through - Universal Remote Control URC-SR3 Owner's Manual

OSD (On-Screen Display) Control
Punch Through
This "Punch Through" enables you to program
the URC-SR3 so that CBL/SAT or DVD/DVR
OSD Controls (GUIDE, MENU, INFO, EXIT,
My Button, Seland 4 Cursor Controls) will also
operate in other component modes on the
remote control.
STEP 1: Press and hold the component
button you want to add OSD Control to, such
as [TV] or [DVD], and the SELECT [SEL] button
at the same time for two seconds until the
Component LED light turns on.
STEP 2: Press the [MENU] button.
The component LED will blink once.
NOTE: If you do not press a button within 30
seconds, the component light will turn off. The
remote will exit the programming mode, and
you will have to start over with step one.
STEP 3: Press either the [CABLE/SAT] or [DVD]
button that you want to use as the source of
OSD Control. The component LED will blink two
times to confirm it is saved.
COMPONENT
BUTTONS
MENU
SELECT
On Screen Display (OSD)
Page | 27