Advertisement
REMOVING A FROZEN BULB
3. ONCE THE BULB IS FREE, DO NOT REMOVE IT COMPLETELY FROM THE REAR LAMP HOLDER.
4. RETURN TO STEP 5 OF THE PRECEDING SECTION.
FAMILIARIZE YOURSELF WITH THE LOCATION AND IDENTIFICATION OF THE
COMPONENTS OF THIS SYSTEM AND ALSO THE NORMAL OPERATION
OF THE SYSTEM BEFORE ATTEMPTING ANY ADJUSTMENT OR SERVICE.
COMPLETELY READ THROUGH AND HAVE A GOOD UNDERSTANDING OF
THE PROCEDURES BEFORE ATTEMPTING TO SERVICE THIS SYSTEM.
FAILURE TO DO SO MAY RESULT IN FATAL INJURY OR EQUIPMENT DAMAGE.
DISCONNECT POWER SOURCE BEFORE SERVICING THIS EQUIPMENT.
EQUIPMENT REQUIRED
1. SCREWDRIVER, Flat Blade, Large
2. WRENCH, 3/8"
1. Remove lower access covers from the ends of the base enclosure by removing the (6) screws
along the sides of each panel with a 3/8" wrench.
2. Note the location and settings of the power supply adjustment taps.
(CONTINUED)
OUTPUT POWER ADJUSTMENT PROCEDURES
ADJUSTMENT INSTRUCTIONS
NOTE
NOTE
WARNING
3. AMMETER, DC Clamp-On
4. VOLT METER, AC/DC
7
Advertisement
