Advertisement
FOCUS AND X-Y ADJUSTMENT INSTRUCTIONS
FAMILIARIZE YOURSELF WITH THE LOCATION AND IDENTIFICATION OF THE
COMPONENTS OF THIS SYSTEM AND ALSO THE NORMAL OPERATION OF THE
COMPLETELY READ THROUGH AND HAVE A GOOD UNDERSTANDING OF THE
PROCEDURES BEFORE ATTEMPTING TO SERVICE THIS SYSTEM. FAILURE TO DO
EQUIPMENT REQUIRED
1. ALLEN WRENCH 5/32'
2. #5 WELDERS GLASSES OR VERY DARK SUNGLASSES
THE SEL10 SYSTEMS PROJECT A VERY INTENSE BEAM OF FULL SPECTRUM LIGHT.
THE USE OF DARK GLASSES WHILE ADJUSTING THE BEAM PARAMETERS ON A
LIGHT COLORED REFLECTIVE SURFACE AT A CLOSE DISTANCE IS MANDATORY.
NEVER LOOK DIRECTLY INTO A LIGHTED FIXTURE'S LIGHT SOURCE.
1. Loosen the positioning fasteners and point the lamphead toward a wall, ceiling, or other flat
surface at least 10 feet away.
2. Locate the focus switch located on the control panel on the back of the lamphead housing.
3. Remove the front cowl and locate the X & Y adjustment holes located on the lower small sides of
the fixture at the ends of the front spider arms.
SEL10 SYSTEMS PROJECT A VERY INTENSE BEAM OF FULL SPECTRUM LIGHT.
CAUTION MUST BE TAKEN WHEN POINTING THE BEAM AT AN OBJECT AT A
DISTANCE OF LESS THAN 100 FEET WITH THE FOCUS SET FOR A CONVERGING
BEAM. COMBUSTIBLE OBJECTS AND OBJECTS WITH A DARK COLOR MAY UNEXPECTEDLY
IGNITE IF CARE IS NOT TAKEN IN THE FOCUSING AND POSITIONING OF THE BEAM.
4. Energize the fixture and ignite the lamp.
5. Adjust the focus by moving the focus switch up or down to produce a diverging beam pattern
with 2-3 clearly defined rings of light with or without an off center hot spot.
6. Adjust the X & Y adjustment screws using a 5/32" allen wrench to move the inner rings of light to
create concentric rings with the hot spot at the center of the light field. Turning the adjustment
screw clockwise will move the rings toward that adjustment axis and turning the screw
counterclockwise will move the rings away from that adjustment axis.
FOR SYSTEMS w/ ELECTRIC FOCUS
SYSTEM BEFORE ATTEMPTING ANY ADJUSTMENT OR SERVICE.
SO MAY RESULT IN FATAL INJURY OR EQUIPMENT DAMAGE.
ADJUSTMENT INSTRUCTIONS
NOTE
NOTE
WARNING
WARNING
WARNING
9
Advertisement
