Advertisement
INSTRUCTIONS FOR REMOVING AND INSTALLING A TYPE "THS" XENON BULB
FAMILIARIZE YOURSELF WITH THE LOCATION AND IDENTIFICATION
OF THE COMPONENTS OF THIS SYSTEM AND ALSO THE NORMAL
OPERATION OF THE SYSTEM BEFORE ATTEMPTING ANY ADJUSTMENT
COMPLETELY READ THROUGH AND HAVE A GOOD UNDERSTANDING OF THE
PROCEDURES BEFORE ATTEMPTING TO SERVICE THIS SYSTEM. FAILURE TO
DO SO MAY RESULT IN FATAL INJURY OR EQUIPMENT DAMAGE.
THE LAMPHEAD SHOULD BE LOCKED IN THE HORIZONTAL POSITION
DISCONNECT POWER SOURCE BEFORE SERVICING THIS EQUIPMENT.
A PROTECTIVE JACKET, FULL FACE SHIELD, AND PROTECTIVE GLOVES MUST
BE WORN AT ALL TIMES WHEN THE LAMP HEAD IS OPENED WITH A BULB
INSTALLED OR WHEN HANDLING THE XENON BULBS. SERIOUS INJURY MAY
OCCUR IF PROPER SAFETY PRECAUTIONS ARE NOT OBSERVED.
READ ALL ENCLOSED INSTRUCTIONS AND INFORMATION SHEETS BEFORE
NEVER OPERATE A FIXTURE WITH AN EXPOSED BULB! THERE IS AN EXTREME
DANGER OF SEVERE BURNS TO EXPOSED SKIN AND EYES FROM THE
ULTRAVIOLET LIGHT EMITTED FROM THE EXPOSED BULB. DAMAGE CAN
OCCUR IN AS LITTLE AS 30 SECONDS OF EXPOSURE. THERE IS ALSO
IN A SEL10 FIXTURE
OR SERVICE.
DURING ANY SERVICE PROCEDURES.
WARNING
WARNING
HANDLING THE BULB.
WARNING
AN ADDITIONAL DANGER FROM FLYING QUARTZ IF AN
EXPOSED BULB EXPLODES!
EQUIPMENT REQUIRED
1. PROTECTIVE SAFETY EQUIPMENT KIT
2. 7/16" END WRENCH OR SOCKET
3. ALLEN WRENCH 5/32"
NOTE
NOTE
NOTE
3
Advertisement
