Cisco Aironet 1200 Series Upgrade Manual page 15

5. Insert the radio card into the access point's mini-PCI connector by
following these steps:
a. Tilt the radio card at approximately 20 to 30 degrees so that its gold
pins are aligned with the mini-PCI connector.
b. Push the card into the slot until it clicks into place.
6. Carefully push the card down (towards the access point's motherboard)
until the card-retaining clips lock into the notches on the side of the card
(you will hear a click when the retaining clips lock into the notches).
7. Carefully position the antenna wires so that their metal connectors do not
touch each other.
Caution
Damage to the radio could occur if the antenna connectors are
touching. If they are, carefully rotate them in opposite
directions until they are separated.
8. Make one final check of the following items:
a. The card is properly secured with both retaining clips engaged.
b. The antenna connectors are not touching.
9. Reinstall the 2.4-GHz radio access cover and use the T-10
tamper-resistant Torx L-wrench to tighten the cover's retaining screw.
15