Table of Contents
Advertisement
3-1.
BASE UNIT
[Setting the Test Mode]
1. First of all, it should be set the
the "TONE" position.
2. Connect the DC power supply to the unit while pressing the
[*]
[#]
button and
button on the BASE UNIT simultaneously.
Beep tone will be heared when test mode is set up.
[Releasing the Test Mode]
To release the test mode, perform as follows:
• Turn off the power (disconnect and reconnect the AC adapter
plug).
• Set the handset to charge on the base unit (except test mode 15).
• Bell in (except test mode 14).
[Changing the Test Mode No.]
[INTERCOM]
• Press the
button.
[Changing the Channel]
[HOLD]
• Press the
button.
Channel will be back to initial channel (CH6), when test mode
No. is changed.
When it is test mode 12 or 13, DTMF will be changed.
CHARGE LED lights for 300 msec every changing of channel
or test mode No.
• Channel rotation
→ CH6 → CH18 → CH1 → CH10 → CH11 → CH25 →
CH2 → CH3 → CH4 → CH5 → CH7 → CH8 →
CH9 → CH12 → CH13 → CH14 → CH15 →
CH16 → CH17 → CH19 → CH20 → CH21 →
CH22 → CH23 → CH24 →
SECTION 3
TEST MODE
[DIAL MODE]
switch (S2) in
– 11 –
3-2.
HANDSET
[Setting the Test Mode]
[VOL]
1. Set
switch (S501) to the minimum position.
[*]
2. While pressing the
button and
SET simultaneously. Beep tone will be heared when test mode
is set up.
[Releasing the Test Mode]
To release the test mode, perform as follows:
[TALK]
• Press the
button or
• Turn off the power (disconnect and reconnect battery connec-
tor).
• Set the handset to charge on the base unit (except test mode 10).
[Changing the Test Mode No.]
• Press the each button of the test mode No.
[Changing the Channel]
[CHANNEL]
• Press the
button.
The channel is back to initial channel (CH6), when test mode No.
is changed.
• Channel rotation
→ CH6 → CH18 → CH1 → CH10 → CH11 → CH25 →
CH2 → CH3 → CH4 → CH5 → CH7 → CH8 →
CH9 → CH12 → CH13 → CH14 → CH15 →
CH16 → CH17 → CH19 → CH20 → CH21 →
CH22 → CH23 → CH24 →
[#]
button on the HAND-
[REDIAL/PAUSE]
button.
Advertisement
Table of Contents
