Cisco Catalyst 2360 Getting Started Manual page 5

Step 5 Connect a Category 5 or 6 Ethernet cable to a port:
Any 10/100/1000 Ethernet downlink port
•
(such as port 1) on the switch front panel.
The Ethernet management port on the switch
•
rear panel.
Connect the other end of the cable to the Ethernet
port on your PC.
Before going to the next step, wait until the port
LEDs on the switch and your PC or laptop are
green or blinking green. The green port LEDs
mean a successful connection.
Troubleshooting:
If the port LEDs do not turn green after about 30
seconds, make sure that:
• You connected the Ethernet cable to one of the
downlink switch ports (not to an uplink port
such as the dual-purpose port).
You are using an undamaged Category 5 or 6
•
Ethernet cable.
The other device is turned on.
•
Step 6 Enter the IP address 10.0.0.1 in a web browser,
and press Enter.
When prompted, enter the default password, cisco.
Note
The Express Setup window appears.
Troubleshooting:
If the Express Setup window does not appear,
make sure that any pop-up blockers or proxy
settings on your browser are disabled and that any
wireless client is disabled on your PC or laptop.
OL-22149-02
The switch ignores text in the username
field.
Running Express Setup
SYST 1X
PS1
PS2
FAN
STAT 11X 13X
DPLX
SPED
22X 25X
35X 37X
Catal yst
2360
47X Series
Catalyst 2360 Switch Getting Started Guide
5