Table of Contents
Advertisement
3.1.3
Sample code
If installed, you can access the sample code, from the following location:
3.2 Starting the software
1. Connect ATOM to the host. See Connecting ATOM to the host (on page 5) for details.
2. Ensure ATOM is switched on.
The On/Off switch is located on the underside of the device, on the same side as the USB and
power connections. See Connecting ATOM to the host (on page 5) for details.
3. Double-click the Access-IS Document Reader shortcut on the host's desktop.
The Access-IS Document Reader opens.
3.3 ATOM status indicators
Four clearly-visible indicators on each side of the device allow you to check the status of ATOM.
Figure 11: ATOM status indicators
If all of these indicators are illuminated, ATOM is switched on, but there is no communication
between ATOM and the document reader software's API.
When ADRS is started, only the blue power icon illuminates; ATOM is in standby mode waiting to
read a document. ATOM is not ready to scan a document if the blue power icon is not illuminated.
Page 13 of 20
Figure 10: Sample code location
Table 3: ATOM status indicators
Icon Description
Good read indicator.
Bad read indicator.
ATOM is busy reading a document, or the detected
document is not stable.
ATOM is switched on and has power.
Communication with the document reader software's
Application Programming Interface (API) is established
and ATOM can read a document.
Copyright © Access-IS 2017
Advertisement
Table of Contents
