Placement Of Speakers; Making The Connections - Panasonic SC-PMX150 Owner's Manual

Placement of speakers

Place the speakers so that the tweeter is on the inner
side. To prevent damage to the speakers, do not touch
the speaker cones if you remove the nets.
Use only the supplied speakers.
The combination of the main unit and speakers give the
best sound. You can cause damage to the system and
decrease the sound quality if you use other speakers.
Note:
• Keep your speakers more than 10 mm (
unit for ventilation.
• Put the speakers on a flat safe surface.
• These speakers do not have magnetic shielding. Do not
put them near TVs, PCs or other equipment easily
influenced by magnetism.
• When you play at high levels for a long period, it can cause
damage to the system and decrease the life of the system.
• Decrease the volume in these conditions to prevent
damage:
- When you play distorted sound.
- When you adjust the sound quality.
CAUTION!
• Use the speakers only with the recommended
system. If not, you can cause damage to the
amplifier and speakers and can cause a fire.
Consult an approved service personnel if damage
occurs or if there is a sudden apparent change in
performance.
• Do the procedures included in these instructions
when you attach the speakers.
4

Making the connections

Connect the AC power supply cord only after all the
Tweeter
other connections have been made.
1
Connect the antenna.
Place the antenna where reception is best.
• If radio reception is poor, use an outdoor antenna
/ q) from the main
13
(not supplied).
32
2
Connect the speakers.
Main unit (rear)
To right speaker
(rear)
Be careful not to cross (short-circuit) or reverse
the polarity of the speaker wires as doing so may
damage the speakers.
2 2
1 1
To household AC outlet
Tape
(not supplied)
i: Red line
j: Copper
Left speaker (rear)
3
Connect the AC power supply cord.
Do not use an AC power supply cord with other
equipment.
Conserving power
The system consumes a small amount of power ( 21),
even when it is in standby mode. Disconnect the power
supply if you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
Connecting other equipment
You can connect a VCR, DVD player etc.
Main unit (rear)
Audio cable (not supplied)
Note:
• Disconnect the AC power supply cord before connection.
• Switch off all equipment and read the appropriate operating
instructions.
• Components and cables are sold separately.
• If you want to connect equipment other than those
described, refer to the audio dealer.
• Sound distortion can occur when you use an adaptor.
e.g. DVD player
(not supplied)