Removing The Cd Tray Fitting & The Vcd Board; How To Eject The Cd Tray Without Turning On Power - JVC MX-J170V Service Manual

Removing the CD Tray fitting & the VCD
board

- How to eject the CD tray without turning on power -

Prior to performing the following procedure, remove
the top cover and the side covers.
ATTENTION: Be sure to remove the CD tray fitting
before removing the CD changer unit.
1. Disconnect the harness from connector PCON1 of
the VCD board.
2. Remove the four screws W attaching the sealed and
VCD board.
3. Turn the black loading pulley gear marked c from the
back of the CD changer unit as shown in Fig.8 and
draw the CD tray toward the front.
4. Move the CD tray fitting upward and release the joint
b.
5. Push and insert the CD tray manually.
CD tray fitting
Joint b
(See Fig.7 to 10)
Joint b
Fig.9
W
Marked c
Loading pulley gear
CD tray
MX-J170V
Fig.7
Sealed
VCD board
PCON1
Fig.8
Fig.10
1-7