Selecting A Sound Mode - Pioneer VSX-D309 Operating Instructions Manual

Sound Modes

Selecting a Sound Mode

To ensure the best possible surround sound, be sure to complete the set up procedures described in "Setting
Up for Surround Sound" (starting on page 14) before using the sound modes. This is particularly important when
2
using the (Dolby) sound mode.
DSP mode
Î
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR CD
1
CD-R/
RECEIVER TUNER TV CONT
TAPE/MD
2
DSP MODE MIDNIGHT 5.1CH
2
1 2 3
CHANNEL TEST SIGNAL
SELECT TONE ATT SELECT
5 6 7
CHANNEL
EFFECT
LEVEL
‡
9 0
ENTER
10 DISC
CH
FUNC
TV CONTROL
VOL VOL
FQ
ST ST
ENTER
MENU
FQ
SOURCE CLASS MPX BAND
7 8 3
D.ACCESS CHANNEL
1 ¡ 4 ¢
LOUDNESS FUNCTION MUTING
FL REMOTE
MASTER
RECEIVER
DIMMER SETUP VOLUME
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
DVD 5.1 ch. input playback
Connect a DVD player with 5.1 channel output to enjoy the surround sound created by 5.1 channel playback.
DVD / LD
MULTI
CONTROL
MULTI CONTROL
DVD/LD TV/SAT VCR/DVR
CD-R/
RECEIVER TUNER
TAPE/MD
2
DSP MODE MIDNIGHT 5.1CH
1 2 3
RECEIVER
CHANNEL TEST
SELECT TONE ATT
5 6 7
CHANNEL
LEVEL EFFECT
‡
9 0
10
DVD 5.1CH
30
1 Press RECEIVER.
This sets the remote to select the sound mode.
(You can skip this step when using the controls on the receiver.)
2 Press DSP MODE to select the sound mode.
Each press changes the DSP mode as follows:
4
8
=HALL 1 = HALL 2 = JAZZ = DANCE
EFFECT
+/–
TOP
MENU
memo
There are two ways to switch on DVD 5.1 CH
mode. With the remote control press the DVD/
Î
LD MULTI CONTROL button. Then press the
CD
RECEIVER button and number button 4 (DVD
TV CONT
5.1CH). On the main unit simply press the DVD
5.1CH button.
4
SIGNAL
SELECT
8
DVD
Press number button 4 (DVD 5.1CH) on the
ENTER
5.1CH
DISC
CH remote to go back to the DVD/LD mode control
To exit this mode using the main unit simply
press other function button (DVD/LD, etc.).
memo
THEATER 2 + THEATER 1 +
The amount of effect of each DSP mode can be adjusted in the
range of 10 to 90 (the default setting is 70) by pressing EFFECT
+/–.
dB
• When 5.1 ch input is selected, Dolby mode, DSP
mode,SIGNAL SELECT, ATT, DIRECT, TONE, MIDNIGHT
mode, LOUDNESS cannot be operated.
• When 5.1ch input is selected, only the volume level
and channel levels can be set.
DSP MODE
Sound