Pioneer VSX-D309 Operating Instructions Manual page 21

4 Point the remote toward the component to
be controlled, enter the 3 digit setup code.
When you enter the setup code, the remote emits a power ON/
OFF signal. If the component turns ON or OFF, you have entered
the proper code.
If the component does not turn ON or OFF and there is more than
one setup code, press @ or # to select another code in step 3 or
try inputting another code (starting again from step 2).
Some manufacturers use several sets of remote control signals and
the first code may not correspond to your component.
dB
dB
Repeat steps 2 through 4 to assign preset codes for as many
components as necessary.
5 Press REMOTE SET UP to exit the preset
mode.
The remote control returns to the previous operation
mode.
• When operating a PIONEER'S DVD/LD player, set the
manufacturer code to "111" in the preset mode.
• All codes enrolled in the manufacturer code list can
be set even if a code is not displayed.
• TUNER cannot be preset.
• If no commands are entered the receiver
automatically exits the preset code mode after 20
seconds.
Preparations
dB
dB
21