Selecting A Sound Mode - Pioneer Elite VSX-21 Operating Instructions Manual

Selecting a Sound Mode

To ensure the best possible surround sound, be sure to complete the set up procedures described in "Setting Up for
Surround Sound" (starting on page 16) before using the sound modes. This is particularly important when using the
(Dolby)/DTS sound mode. When using the sound modes, SPEAKERS A are used. If SPEAKERS B are selected and a
sound mode is turned on, selection automatically switches to SPEAKERS A only.
Surrround operation
RECEIVER TV
FQ
+
ENTER
–
FQ
VOL VOL
CHANNEL
MULTI CONTROL
DVD/LD TV/SAT CD
VCR 1 TUNER
TV CONTROL
VCR 2 RECEIVER MD/TAPE
DSP MODE MIDNIGHT
2
1 2 3 4
CH.SELECT
TEST TONE ATT SIG.SELECT
5 6 8
7
CN.LEVEL
EFFECT
9 0 +10
MEMU
CLASS TV/VCR
FUNCTION DIRECT FL DIMMER
COMMANDER
MODE CHECK SET UP
Î
AUDIO/VIDEO PRE-PROGRAMMED
REMOTE CONTROL UNIT
1
Press RECEIVER.
This sets the remote to select the sound mode.
(You can skip this step when using the controls on the receiver.)
2
Select the sound mode.
• For
• For DSP modes \ Press DSP MODE repeatedly
Each press changes the DSP mode as follows:
1
=HALL 1 = HALL 2 = JAZZ = DANCE
SFC OFF+ THEATER 2 + THEATER 1 +
ATT
memo
EFFECT +/–
• The amount of effect of each DSP mode can be adjusted in the range of 10
to 90 (the default setting value is 70) by pressing EFFECT +/–.
2
(Dolby)/DTS mode \ Press
Sound Modes
31
<ARB7181>