Connecting Your Usb Device To The Receiver; Basic Playback Controls - Pioneer VSX-819H Operating Instructions Manual

Other connections
• Push down on the PUSH OPEN tab to
access the USB terminal.
iPod
USB VIDEO
MULTI-ZONE
SPEAKERS
CONTROL ON/OFF
iPod VIDEO INPUT
USB VIDEO L AUDIO R
USB mass
storage device
Connecting your USB device to the
receiver
1 Switch on the receiver and your TV.
2 Press iPod USB on the remote control to
switch the receiver to the iPod USB.
NO DEVICE appears in the OSD.
3 Connect your USB device.
The USB terminal is located on the front panel.
Loading appears in the OSD as this receiver
starts recognizing the USB device connected.
After the recognition, a playback screen appears
in the OSD and playback starts automatically.
 P L AY
U S B 0 0 1 / 0 0 4
M P 3 R : F l d S : O n
R e l a x Yo u r B o d y
K e v i n J a c k s o n
W e a r e a l l o n e
   3 2 k b p s
R e t u r n
Note
1 Make sure the receiver is in standby when disconnecting the USB device.
2 • If the file selected cannot be played back, this receiver automatically skips to the next file playable.
• When the file currently being played back has no title assigned to it, the file name is displayed in the OSD instead; when
neither the album name nor the artist name is present, the row is displayed as a blank space.
• Note that non-roman characters in the playlist are displayed as *.
• It is not possible to output the USB audio to ZONE 2.
VIDEO INPUT
L AUDIO R
MASTER
VOLUME
MCACC
SETUP MIC
This receiver
1
File/Folder number
File format
Repeat or Shuffle
Song name
Artist name
Album name
Elapsed time
0 : 0 1
Bit rates

Basic playback controls

The following table shows the basic controls
on the remote for USB playback. Press iPod
USB to switch the remote control to the iPod
USB operation mode.
Button What it does

Starts normal playback.

Pauses/unpauses playback.
/
Press to skip to previous/next track.
 
/ Press and hold during playback to
start scanning.
Press repeatedly to switch between
Repeat Folder, Repeat One and
Repeat All.
Press repeatedly to switch between
Shuffle On and Shuffle Off.
DISPLAY
Press repeatedly to change the song
playback information displayed in the
front panel display.
/
During playback, press to skip to
previous/next track.
/
TOP MENU Press to return to the menu screen.
RETURN
Press to return to the previous level.
Important
If a USB Error message lights in the display,
try following the points below:
2
• Switch the receiver off, then on again.
• Reconnect the USB device with the
receiver switched off.
• Select another input source (like BD), then
switch back to iPod USB.
• Use a dedicated AC adapter (supplied with
the device) for USB power.
For more information on error messages, see
USB messages on page 68.
If this doesn't remedy the problem, it is likely
your USB device is incompatible.
11
61
En