Ipod Messages; Usb Messages; Sirius Radio Messages - Pioneer VSX-819H Operating Instructions Manual

12 Additional information

iPod messages

Symptom Cause
iPod/USB Error 1 There is a problem with the signal path from the
iPod to the receiver.
(I/U ERR1)
iPod/USB Error 2
The software version being used with the iPod
needs to be updated.
(I/U ERR2)
An iPod not supported by this receiver is
connected.
iPod/USB Error 3 When there is no response from the iPod.
(I/U ERR3)
No Track
When there are no tracks in the category
selected on the iPod.

USB messages

Symptom Cause
iPod/USB Error 1
There is a problem with the signal path from the
USB to the receiver.
(I/U ERR1)
iPod/USB Error 3
When there is no response from the USB.
(I/U ERR3)
iPod/USB Error 4
The power requirements of the USB device are
(I/U ERR4) too high for this receiver.

SIRIUS radio messages

Symptom
ANTENNA
CHECK SIRIUS TUNER
LINKING
UPDT ***%
UPDATING
INVALID CHANNEL
68
En
Cause
Antenna is not properly connected.
SIRIUS Connect tuner is not properly connected Check that the 8 pin mini DIN cable
The SIRIUS signal is too weak at the current
location. There is no SIRIUS signal or the
SiriusConnect Tuner is connected.
Unit is updating subscription.
Unit is updating channels.
Selected channel is not available/does not exist. Select another channel.
Action
Switch off the receiver and reconnect the iPod to
the receiver. If this doesn't seem to work, try
resetting your iPod.
Update the software being used with the iPod
(please use the latest iPod software versions
later than the iPod updater 2004-10-20).
Connect the iPod supported by this receiver.
Update the iPod software to the latest version. If
this doesn't seem to work, try resetting your iPod.
Select a different category.
Action
Switch off the receiver and reconnect the USB to
the receiver.
Switch off the receiver and reconnect the USB to
the receiver.
Switch off the receiver and reconnect the USB to
the receiver.
Action
Check that the antenna cable is
attached securely.
and AC Adapter are attached securely.
n/a
Wait until the encryption code has
been updated.
Wait until the encryption code has
been updated.