Connecting To The Front Panel Video Terminal; Connecting Antennas - Pioneer VSX-819H Operating Instructions Manual

03 Connecting up
Connecting to the front panel
video terminal
Front video connections are accessed via the
front panel using the INPUT SELECTOR or
VIDEO button on the remote control. There are
standard audio/video jacks. Hook them up the
same way you made the rear panel connections.
• Push down on the PUSH OPEN tab to
access the front video connections.
iPod
USB
This receiver
MULTI-ZONE
SPEAKERS
CONTROL ON/OFF
iPod VIDEO INPUT
USB VIDEO
VIDEO
AUDIO/VIDEO OUTPUT
20
En
VIDEO INPUT
VIDEO L AUDIO R
L AUDIO R
MCACC
SETUP MIC
Video camera
(etc.)
L R

Connecting antennas

Connect the AM loop antenna and the FM wire
antenna as shown below. To improve reception
and sound quality, connect external antennas
(see Using external antennas on page 21).
4
MASTER
VOLUME
1 Push open the tabs, then insert one wire
fully into each terminal, then release the tabs
to secure the AM antenna wires.
2 Fix the AM loop antenna to the attached
stand.
To fix the stand to the antenna, bend in the
direction indicated by the arrow (fig. a) then
clip the loop onto the stand (fig. b).
3 Place the AM antenna on a flat surface
and in a direction giving the best reception.
4 Connect the FM wire antenna in the same
way as the AM loop antenna.
For best results, extend the FM antenna fully
and fix to a wall or door frame. Don't drape
loosely or leave coiled up.
fig. a fig. b
2
ANTENNA
AM 3
LOOP
1