Table of Contents
Advertisement
3
Operation
A. Your First Fire
Read these instructions carefully and familiarize yourself
with the burner controls. Locate the pilot assembly, Figure
14. Follow the lighting instructions on the next page exactly.
During the first fire, it is not unusual to smell some odor
associated with new logs, paint and metal being heated.
Odors should dissipate within the first eight to ten hours,
however, you can open a window to provide fresh air to
alleviate the condition.
B. Pilot and Burner Inspection
Each time you light your heater check that the pilot flame and
burner flame patterns are as shown in Figures 16 and 17. If
flame patterns are incorrect, turn the heater off. Contact your
dealer or a qualified gas technician for assistance. Do not
operate the heater until the pilot flame is correct.
Follow regular maintenance procedures as described in the
Maintenance section of this manual.
ST673
Figure 14 - Pilot assembly location.
RUVSOD
Pilot assembly location
C. Flame & Temperature Adjustment - RN/RP
7/249/01 djt
Models
For units equipped with 'HI/LO' valves the flame adjustment
is accomplished by rotating the 'HI/LO' adjustment knob
located near the center of the gas control valve. (Figure 15)
12
Natural
Pilot
LP Pilot
Monessen • Sundance VF Installation Manual_R1 • 04/17
Turn
counterclockwise
to increase
flame height
Figure 15 - Flame adjustment knob for SIT Valve.
D. Flame Characteristics
FP390
FLAME ADJUSTMENT KNOB
It is important to periodically perform a visual check of the
11/21/96
pilot and burner flames. Compare them to the pictorial
illustrated below. (Figs. 21 & 22) If the flame patterns appear
abnormal contact a qualified service provider for service and
adjustment.
Figure 16 - Correct pilot flame appearance.
ST198
pilot flame detail
11/99
Figure 17 - Correct burner flame pattern.
LG224
UVS27
logs in place
1/30/02 djt
Turn clockwise
to decrease
flame height
3-90-733069
Hide quick links:
Advertisement
Table of Contents
