Table of Contents
Advertisement
3. Install the right log by placing it on the sheet metal bracket
behind the grate with the right end of the log, "the thicker
end", touching the grate and the right side the firebox.
Swing the left end of the log "painted end", backward until
it comes in contact with the branch on the rear log. Set
the log down over the bent tab on the right. When the log
is in place it rests on the tab mentioned earlier and the
tip of it comes in contact with the branch on the rear log.
(Figure 10)
4. Install the left log by placing it on the sheet metal bracket
behind the grate with the left end of the log, "the thicker
end" touching the grate and the left end of the firebox.
Lay the log into the recessed area on the left branch of
the rear log. When the log is in place, it will rest on the left
branch of the rear log toward the left side of the branch.
5. Loosely sprinkle the lava rocks directly on top of the
burner just behind decorative grate. (Figure 11) Do not
place lava rocks toward back of burner. The lava rock is
shipped inside the bag assembly.
Left Log
Rear Log
Figure 10 - Install rear, left and right logs.
LG223
UVS27
log placement
1/30/02 djt
Figure 11 - Sundance logs in place.
11
Right Log
Monessen • Sundance VF Installation Manual_R1 • 04/17
LG224
UVS27
logs in place
Complete the Installation
1. Install the screen frame by sliding the hooks over the
top front edge of the firebox and resting the bottom
on the support brackets. Rotate the top edge of the
assembly toward the firebox, and center it. Rotate the
right and left cams towards the back of the firebox to
secure glass frame in place.
2. Grasp the front plate by the window bars and lift
into position engaging the two steel tabs behind the
adjacent bosses in the side plates. (Figure 12) Seat
the front against the sides so the tabs at the bottom
lip engage with the notches in the stove legs.
Engage steel tabs
behind the cast
iron bosses
Figure 12 - Install the Front Plate. Your Front may look different
from that shown.
When properly installed, the bottom of the front plate cannot
be pulled away form the sides without lifting it.
NOTE: Be sure the control door can swing out. It should close
against the steel tab stop.
ST112a
front plate install
fully assembled
If installing the optional warming shelf, you may find it easiest
1/04
to attach it to the top plate before placing the top in position
on the stove. Follow the instructions supplied with the kit.
3. Lay the screen and top grille in place. (Figure 13)
This completes assembly of the Sundance.
Leveling
Screws
Figure 13 - Install the Top Plate and Grille.
ST114a
top install
12/18/03 djt
Control Door
Bottom Tabs engage
notch in the leg.
Grille
Screen
3-90-733069
Hide quick links:
Advertisement
Table of Contents
