Commodore PC 20 User Manual page 433

Invalid time
[Time]
• You specified an invalid time.
Refer
to
Chapter 3,
"MS·DOS
Commands," for the correct syntax,
and try the command again.
Invalid Volume 10
[Format]
• Format displays this message if you enter a volume label that
doesn't match the label on the hard disk you want to format
It
then quits the format process.
Use the
vol
command to find out what the volume label for the
hard disk is, then try the command again.
Label not found
[MS.DOS]
• Your batch file contains a Goto command to a nonexistent
label
Last backup diskette not inserted
Insert last backup diskette in drive x:
Strike any key when ready
[Backup]
• This message prompts you for the final backup disk
After you have put the final backup disk into the drive speci-
fied, press any alphanumeric key to continue the backup
process.
***
Last file not backed up
***
[Backup]
• Backup could not back up the last file on the disk This mes-
sage may occur if there is no more room on the target disk.
It
may also occur if there was an error in the source file, or on
the target disk
You may· have to back up this file separately to another disk.
Line too long
[Edlin]
• During an Edlin R (replace) command, the string given as the
replacement caused the line to expand beyond the limit of
253 characters.
You should divide the long line into two lines and retry the R
command.
/-L
2951
L