Table of Contents
Advertisement
Pluto User Manual v1.38
Linus Cage Generator.
Always be careful when switching Dual Head Enable on or off as this may
interrupt the signal to another destination!
When configuration is set to Dual Head, an option appears to select which head
appears in the Pluto Node list from the
one of the choices, detailed below, and click OK.
Select
Head A Only
Note that this setting simply sets which head that THIS particular workstation is
controlling and is remembered even if the application is closed and restarted.
Another workstation can be used to control the other head simultaneously. The
setting is stored and recalled separately for each Pluto.
Select
Heads A & B
GUI. In this case two nodes will appear in the main window node list (as shown
in the examples below).
Switching to or from dual-head, or switching between
causes the Pluto Node list to be rescanned as the nodes will change. This means
that the current node is unselected and the routing tab is disabled. Go to the
Pluto tab to reselect the appropriate node.
See Appendix A for examples of how a Pluto may be set up for use in
Dual Head Mode.
In Dual-head configuration, the Pluto Tab will indicate which Head of the Pluto is
currently being controlled by that workstation.
Pandora Technology
United Kingdom
or
Head B Only
to allow independent control of both Heads from the same
In this example, PLUTO 1 is in Standard mode. PLUTO 2
is in Dual Head mode, and this GUI is controlling Head A
only.
sales@pandoratek.org
www.pandora-int.com
Show Nodes
to independently control the required Head.
Page 23 of 66
drop down menu. Select
Show Nodes
October 2013
options,
Advertisement
Table of Contents
