Adjustment With The Programmed Software; Position Of The Light Sensor - Pentax MZ-7 QUARTZ DATE Service Manual

3) Remote control mode – Select the mode (
The self-timer LED should flash, and the shutter should be released by the transmitter.
4) Set the mode dial at "Tv" and operate the select lever, Tv and Av display should be changed.
The Bar Graph in the viewfinder should be displayed when the Side button is pressed, and
the 1/30 or slower speed should be displayed by orange color. (With FA(F) 50 mm lens)
5) The ISO film speed and PCV Beep tone should be able to selected by the select button at
the "ISO" or (
6) At the AUTO PICT mode and MF(AF-SW) mode, cover the front of the lens by hand, and
press the shutter button half way, the flash should pop-up automatically and the back light
on the external LCD panel should light up.
At the "AF" mode, cover the front of the lens by hand, and press the shutter button half
way, the flash should be fired continuously to help the focusing.
7) When the flash button (
( ) should be off
At the Red-eye reduction mode (

6-2. Adjustment with the programmed software

27550 programmed soft (Exclusive use)
The other items and the method of connection are same as MZ-5.
1) The method of adjustment is same as MZ-5.
2) The positioning of AF frame (Viewfinder) and AF sensor and AF chart are same as MZ-10.

6-3. Position of the Light sensor

1) The method of adjustment is same as MZ-5.
2) The position is a same as MZ-10. (Refer to the figure below)
3.4
) position of the mode dial.
) is pressed, the flash should pop-up and the Auto-flash mark
), the flash should be fired twice.
AF frame
) by the drive button (
0.5mm± ± ± ± 0.5mm/actual size
（0.0∼+1.0mm）
Center of the Light sensor
Center of the AF frame
27550
)
7/9