Instrument Cluster Indicator Lights - Jeep Wrangler 2015 User Manual

WHAT TO DO IN EMERGENCIES
- Seat Belt Reminder Light
When the ignition switch is first turned to ON/RUN, this light will turn on for four to
eight seconds as a bulb check. During the bulb check, if the driver's seat belt is
unbuckled, a chime will sound. After the bulb check or when driving, if the driver seat
belt remains unbuckled, the Seat Belt Reminder Light will flash or remain on
continuously.

INSTRUMENT CLUSTER INDICATOR LIGHTS

– Turn Signal Indicator
The arrows will flash with the exterior turn signals when the turn signal lever is
operated. A tone will chime, and a EVIC message will appear if either turn signal is
left on for more than 1 mile (1.6 km).
NOTE:
If either indicator flashes at a rapid rate, check for a defective outside light bulb.
– High Beam Indicator
Indicates that headlights are on high beam.
– Front Fog Light Indicator
This indicator will illuminate when the front fog lights are on.
– Front Axle Lock Indicator
Indicates that the front axle is locked.
- Rear Axle Lock Indicator
Indicates that the rear axle is locked.
– Vehicle Security Light
This light will flash rapidly for approximately 15 seconds when the vehicle security
alarm is arming. The light will flash at a slower speed continuously after the alarm is
set. The security light will also come on for about three seconds when the ignition is
first turned on.
– 4WD Indicator
This light indicates the vehicle is in 4-wheel drive (4WD) mode.
- Sway Bar
Indicates that the sway bar has been disconnected.
117