Saving Station Presets; Naming Station Presets; Listening To Station Presets - Pioneer VSX-82TXS Operating Instructions Manual

Using the tuner

Saving station presets

If you often listen to a particular radio station, it's
convenient to have the receiver store the frequency for
easy recall whenever you want to listen to that station.
This saves the effort of manually tuning in each time. This
receiver can memorize up to 30 stations, stored in three
banks, or classes, (A, B and C) of 10 stations each. When
saving an FM frequency, the MPX setting (see page 32) is
also stored.
SYSTEM OFF D.ACCESS
+10
INPUT
RECEIVER SOURCE
SELECT
AV PARAMETER
TOP MENU
TUNE
ST
DTV MENU
SETUP
TUNE
CATEGORY
GUIDE
TV CONTROL
CD TV VIDEO 2
INPUT
DVD SAT VIDEO 1 TV CONT
TV VOL
SELECT
DVR2 CD-R XM RADIO ROOM2/3
DVR1 i Pod TUNER RECEIVER
REC
SLEEP VIDEO ANALOG
SEL ATT
1 Tune to a station you want to memorize.
See Listening to the radio on page 32 for more on this.
2 Press T.EDIT (TUNER EDIT).
The display shows STATION MEMORY, then a blinking
memory class.
3 Press CLASS to select one of the three classes then
press ST to select the station preset you want.
You can also use the number buttons to select a station
preset.
4 Press ENTER .
After pressing ENTER, the preset class and number stop
blinking and the receiver stores the station.

Naming station presets

For easier identification, you can name your station
presets.
1 Choose the station preset you want to name.
See Listening to station presets below for how to do this.
2 Press T.EDIT (TUNER EDIT).
The display shows STATION NAME, then a blinking
cursor at the first character position.
3 Input the name you want.
Choose from the following characters for a name up to
four characters long.
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
∗
!"#$%&'() +,–./:;<=>?@[ \ ]^_{|} ˜
• Use the ST buttons (remote) to select
characters.
• Press ENTER to confirm a character. If no character
is input, a space is input.
ENTER
CLASS
MPX REC STOP MEMORY
DISC
ENTER ENTER
CH LEVEL
AUDIO SUBTITLE HDD DVD
MENU
DISP CH CH
PHOTO
ST
T.EDIT STATUS SIGNAL SEL SBch STEREO
ENTER
RETURN
MULTI OPE THX STANDARD ADV. SURR
BAND
SHIFT
PHASE MCACC S.DIRECT
VOL
TV CH
RECEIVER
DTV INFO MUTE
• The name is stored when ENTER is pressed after
choosing the fourth character.
Tip
• To erase a station name, simply repeat steps 1-3 and
input four spaces instead of a name.
• Once you have named a station preset, you can press
DISP when listening to a station to switch the display
between name and frequency.

Listening to station presets

You will need to have some presets stored to do this. See
Saving station presets above if you haven't done this
already.
1 Press TUNER to select the tuner.
2 Press CLASS to select the class in which the station
is stored.
Press repeatedly to cycle through classes A, B and C.
3 Press ST to select the station preset you want.
• You can also use the number buttons on the remote
control to recall the station preset.
06
33
En