Selecting Preset Codes Directly; Direct Function; Clearing All The Remote Control Settings - Pioneer VSX-818V Operating Instructions Manual

09 Controlling the rest of your system

Selecting preset codes directly

RECEIVER
SOURCE
INPUT SELECT
MULTI CONTROL
TV CTRL
DVD TV DVR
CD-R XM SIRIUS
CD FM AM
STEREO/
1 While pressing the RECEIVER button,
press and hold the ' 1 ' button.
The LED blinks.
2 Press the MULTI CONTROL button for the
component you want to control.
The LED lights on continuously.
3 Use the number buttons to enter the
preset code.
You can find the preset codes on page 54.
The LED blinks again after you enter the code.
If the correct code has been input the power of
the component being input will turn on or off.
The power of the component being input will
only turn on or off if that component is able to
be turned on directly by remote control.
• You can only input a code for the component
type written on each MULTI CONTROL
1
button.
• Even if you don't input a preset code for the
TV (TV MULTI CONTROL button) you will
be able to control your TV using the
dedicated TV CONTROL on the remote if
you have assigned it to the TV CTRL button.
4 Repeat steps 2 through 3 to try a different
code, or to enter a code for another
component you want to control.
5 When you're done, press RECEIVER .
Note
1 • TV codes (for example, codes for TV, CATV, Satellite TV or DTV) can only be assigned to the TV or TV CTRL button.
• You can't assign the FM / AM or RECEIVER buttons.
2 You can't use direct function with the FM / AM and TV CTRL functions.
50
En
TUNER DISP CLASS MPX
MIDNIGHT ANALOG ATT DIMMER
PORTABLE
SIGNAL SEL
iPod
INFO TV CONTROL
RECEIVER
INPUT

Direct function

• Default setting: ON
You can use the direct function feature to
D.ACCESS
control one component using the remote
ENTER
control while at the same time, using your
SLEEP
receiver to playback a different component.
iPod CTRL
This could let you, for example, use the remote
control to set up and listen to a CD on the
receiver and then use the remote control to
rewind a tape in your VCR while you continue
to listen to your CD player.
When direct function is on, any component
you select (using the MULTI CONTROL
buttons) will be selected by both the receiver
and the remote control. When you turn direct
function off, you can operate the remote
control without affecting the receiver.
1 While pressing the RECEIVER button,
press and hold the '4' button.
The LED blinks.
2 Press the MULTI CONTROL button for
the component you want to control.
The LED lights on continuously.
3 Use the number buttons to enter either
'1' (direct on) or '2' (direct off).
The LED blinks again.
4 Repeat steps 2 through 3 for the other
components you want to control.
5 When you're done, press RECEIVER .
Clearing all the remote control
settings
You can clear all presets and restore the
factory default settings.
• While pressing the RECEIVER button,
press and hold the '0' button for three
seconds.
The LED blinks three times indicating the settings
have been restored to the factory presets.
2