Choosing The Input Signal - Pioneer VSX-415-S/-K Operating Instructions Manual

Listening to your system
The MCACC indicator on the front panel lights
when Acoustic Calibration EQ is active.

Choosing the input signal

• Default setting: AUTO
You need to hook up a component to both
analog and digital inputs on the rear of the
receiver to select between input signals.
VSX-515 model:
ADVANCED
STANDARD SURR
LISTENING MODE
VSX-415 model:
ADVANCED STEREO/
STANDARD
SURROUND DIRECT
LISTENING MODE
SPEAKER
EON
MUTE
IMPEDANCE MODE
• Press SIGNAL SELECT to select the input
signal corresponding to the source compo-
nent.
Each press cycles through the options as
follows:
• AUTO – This automatically switches to
DIGITAL if a digital source is detected,
otherwise it remains on ANALOG.
• ANALOG – Selects the analog inputs.
• DIGITAL – Selects the digital input.
When set to DIGITAL or AUTO, 2 DIGITAL
lights when a Dolby Digital signal is input, and
DTS lights when a DTS signal is input.
Note
1 • You can't use Acoustic Calibration EQ when DVD 5.1ch is on, and it has no effect when headphones are connected.
• If you switch on Acoustic Calibration EQ when DIRECT is selected, the receiver automatically switches to STEREO.
2 • This receiver can only play back Dolby Digital, PCM (32kHz–96 kHz), DTS and (VSX-515 model only) WMA9 Pro digital signal
formats. With other digital signal formats, set to ANALOG.
• You may get digital noise when a LD or CD player compatible with DTS is playing an analog signal. To prevent noise, make
the proper digital connections (page 16) and set the signal input to DIGITAL.
• Some DVD players don't output DTS signals. For more details, refer to the instruction manual supplied with your DVD player.
1
2
ST/DIRECT SIGNAL
/AUTO SURR SELECT
SIGNAL
VSB
SELECT MODE
TUNER QUICK
PTY
EDIT TONE
SEARCH SETUP
MULTI JOG
06
35
En