Table of Contents
Advertisement
First try to find a solution to the problem (refer to
the table). If the problem persists, contact the
Authorised Service Centre.
With some problems, the acoustic signals
operate and the display shows an alarm
code:
•
- The appliance does not fill with water
properly.
•
- The appliance does not drain the water.
•
- The appliance door is open or not
closed correctly. Please check the door!
POSSIBLE FAILURES
Problem
The programme does not
start.
The appliance does not fill
with water properly.
The appliance does not fill
with water and drain imme-
diately.
The appliance does not
drain the water.
The spin phase does not
operate or the washing cy-
cle lasts longer than usual-
ly.
22
•
•
•
Make sure that the mains plug is connected to the mains socket.
•
Make sure that the appliance door is closed.
•
Make sure that there is not a damaged fuse in the fuse box.
•
Make sure that the Start/Pause has been pressed.
•
If the delay start is set, cancel the setting or wait for the end of
countdown.
•
Deactivate the Child Lock function if it is on.
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low. For
this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the filter of the inlet hose and the filter of the valve
are not clogged. Refer to "Care and cleaning".
•
Make sure that the inlet hose has no kinks or bends.
•
Make sure that the connection of the water inlet hose is correct.
•
Make sure that the connections of the water inlet hoses are correct.
•
Make sure that the drain hose is in the correct position. The hose
may be too low. Refer to 'Installation instruction'.
•
Make sure that the sink spigot is not clogged.
•
Make sure that the drain hose has no kinks or bends.
•
Make sure that the connection of the drain hose is correct.
•
Set the drain option if you set a programme without drain phase.
•
Set the drain option if you set an option which ends with water in
the drum.
•
Make sure that the drain filter is not clogged. Clean the filter, if nec-
essary. Refer to 'Care and cleaning'.
•
If problem remains please contact the Authorised Service Centre.
•
Set the spin option.
•
Set the drain option if you set an option which ends with water in
the drum.
•
Make sure that the drain filter is not clogged. Clean the filter, if nec-
essary. Refer to 'Care and cleaning'.
•
Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
- The mains supply is unstable. Wait until
the mains supply is stable.
- No communication between electronic
elements of the appliance. Switch off and
switch on again.
WARNING! Deactivate the appliance
before you do the checks.
Possible solution
Advertisement
Table of Contents
