Whirlpool AWZ9CD/PRO Use And Installation Manual page 110

a ventilation grid (minimum
45 cm x 8 cm), in the rear part
of the worktop under which
the dryer is installed .
ELECTRICAL WARNINGS
Make sure the voltage
specified on the rating plate
corresponds to that of your
home .
For installation to comply with
current safety regulations,
an omnipolar switch with
minimum contact gap of 3mm
is required .
Regulation require that the
dryer is earthed .
For dryers with fitted plug,
if the plug is not suitable for
you socket outlet, contact a
qualified technician .
Do not use extension leads,
multiple sockets or adapters .
Do not connect the dryer to a
socket which can be operated
by remote control .
The power cable must be
long enough for connecting
the dryer, once fitted in its
housing, to the main power
supply .
Do not pull the power supply
cable .
If the power cable is damaged
it must be replaced with an
identical one . The power
cable must only be replaced
by a qualified technician
in compliance with the
manufacturer instruction and
current safety regulations .
Contact an authorized service
centre .
Do not operate this dryer if
it has a damaged mains cord
or plug, if it is not working
properly, or if it has been
110
damaged or dropped . Do not
immerse the mains cord or
plug in water . Keep the cord
away from hot surfaces
The electrical components
must not be accessible to the
user after installation .
Do not touch the dryer with
any wet part of the body
and do not operate it when
barefoot .
CORRECT USE
Do not exceed the maximum
load allowed . Check the
maximum load allowed in the
programme chart .
Do not dry unwashed items in
the tumble dryer .
Do not overdry the laundry .
Take care that no lint or dust is
accumulated around the dryer .
Fabric softeners, or similar
products, should be used as
specified by the fabric softener
instructions .
CLEANING AND
MAINTENANCE
The dryer must be
disconnected from the power
supply before carrying out
any cleaning or maintenance
operation .
Never use steam cleaning
equipment .
The dryer shall be
disconnected from the power
supply during service and
when replacing parts . The
operator must be able to check
from any of the points to which
he has access that the plug
remains removed .
SOUND LEVEL
Sound pressure level,
Lpa <70 dB(A)
(Kpa: +/– 2,5 dB(A)