Whirlpool AWZ9CD/PRO Use And Installation Manual page 130

FAILURE INDICATOR AND MESSAGES
Make sure to
• Empty the water tank after each programme
• Clean the door filter after each programme
• Clean the bottom filter after five cycles
Failure Indicator Possible Cause
Water tank may be
• filled with water
• not correctly positioned
Bottom filter may be
• blocked by lint
• not correctly positioned
Door filter may be
• blocked by lint
• not correctly positioned
Refer to section CARE AND MAINTENANCE for
emptying water tank or cleaning filters .
130
Solution
• Empty water tank; make sure to insert it properly
afterwards .
• Push in the water tank to make sure that it is
correctly inserted in the tank compartment .
• Clean the bottom filter; make sure to insert it
properly afterwards
• Push in the bottom filter and move the release
levers into vertical position, to make sure that the
filter is correctly inserted in the filter compartment .
Close the flap .
• Remove and clean the door filter; make sure to
insert it properly afterwards so that it completely
integrates in the filter compartment .
• Check position of the door filter; make sure that it
is properly inserted in the filter compartment .