Important Safety Notes; Operation - S&P EP-3N User Instructions

GB
PORTABLE FAN HEATERS
Before any installation or connection we would
advise that the following instructions are carefully
read. The enclosed information specifies the
correct and safe procedures for installation and
operation of the appliance.
All S&P EP -Portable Fan Heaters comply with
European Safety Standards.
All appliances are supplied in perfect condition
and operation, however if found to be defective
the unit should be returned to the supplier in
accordance with the terms of the S&P guarantee.
These instructions should be saved and left in an
appropriate place near the appliance for future
reference.

IMPORTANT SAFETY NOTES

– All installation work should be carried out by a
suitably qualified person(s); and in accord-
ance with all applicable standards and
regulations pertaining to the country of
installation.
– When the heater is operating, the mains
electrical supply cable must be routed away
from the direct source of radiated heat.
– Do Not Site the appliance by the side of a wall
/ unit constructed from combustible materials
(plastic, wood etc..). The appliance must be
installed at a minimum distances of 50cm
away from other appliances / fixed objects.
– Do Not Site the appliance directly under an
electrical connection socket.
– Do Not Cover the appliance with objects which
would restrict the flow of air.
– Before any cleaning or maintenance the
appliance must be disconnected and isolated
from the mains electrical supply. The only
areas on the appliance that require cleaning
(only wiping with a damp, not wet cloth) are
the intake and extract air vents.
– Do Not Operate this appliance with wet hands.
– Do Not Site the appliance within the direct
vicinity of a bath, shower, swimming pool or
other area where it could come into direct
contact with water.
– If the electrical supply cable if found to be
damaged then the appliance Must Not Be
Used. The appliance must be returned to an
authorised supplier or repaired by a suitably
qualified person.
IMPORTANT SAFETY NOTES FOR
INSTALLATION
– ENSURE THE APPLIANCE IS DISCONNECTED
FROM THE MANIS ELECTRICAL SUPPLY
BEFORE COMMENCING INSTALLATION.
– THE EC PORTABLE FAN HEATERS ARE
CERTIFIED FOR SAFE USE WITHIN ENVIRON-
MENTS WITH HIGH LEVELS OF RELATIVE
HUMIDITY.
– BEFORE MAKING ELECTRICAL CONNECTION
FOR THE FIRST TIME ENSURE THAT THE
VOLTAGE AND FREQUENCY OF THE ELEC-
TRICAL SUPPLY MATCHES THAT OF THE
APPLIANCE DATA PLATE LABEL.
– THIS PRODUCT MUST BE EARTHED. DO NOT
CONNECT TO MULIPLE PLUG SOCKETS.
IMPORTANT
The appliance must be installed in accordance
with the minimum recommended distances from
other appliances / fixed objects as detailed in
Figure (1).

OPERATION

– The EC heater includes two rotary switches
located on the front casing facia. One switch
offers a four position control of the fan and
heater functions, where the second switch
operates as a thermostat to regulate the
environmental temperature (heater output).
– The four position fan and heater switch
operates as follows:
O OFF
Fan Only
Fan + Low Level Heating
Fan + High Level Heating
– When the switch, situated on the back of the
casing fig. (3), is in the
heater operation is controlled through the
thermostat; switching the heater off when the
desired temperature is reached. In this switch
position only the