Connecting The System Remote Control - Pioneer Elite PRO 510HD Operating Instructions Manual

CONNECTING THE SYSTEM REMOTE
CONTROL
When the control terminals of Pioneer audio/video units
with the Î mark are connected, these units can be operated
using the Monitor's remote control unit (see pages 72 to
77).
NOTES:
• When the Pioneer unit with Î mark is connected to the
CONTROL IN terminal of the projection monitor, the remote
sensor of the projection monitor does not accept signals from
the remote control unit. In this case, point the remote control at
the first device in the chain (the equipment with no CONTROL
IN connection).
• To connect the control cord, use the commercially available mini
plug cord (monaural).
(When operating Pioneer units with Î mark)
<Connect as shown>
CONTROL
IN OUT
To other units bearing
the Î mark.
IN OUT IN OUT
CONTROL CONTROL
67
<ARB1527>