Connecting The System Remote Control - Pioneer ELITE PRO-620HD Operation Instruction Manual

CONNECTING THE SYSTEM REMOTE
CONTROL
If you want to control are your Pioneer equipment with the
remote for this unit, you can daisy-chain the components.
Connect the audio/video components using the pioneer Î
terminals as shown below. See page 76 to 81 for how to
control other components.
NOTES:
• When the Pioneer unit with Î mark is connected to the
CONTROL IN terminal of the projection monitor, the remote
sensor of the projection monitor does not accept signals from
the remote control unit. In this case, point the remote control at
the this unit in the chain (the equipment with no CONTROL IN
connection).
• To connect the control cord, use the commercially available mini
plug cord (monaural).
(When operating Pioneer units with Î mark)
<Connect as shown>
CONTROL
IN OUT
To other units bearing
the Î mark.
IN OUT IN OUT
CONTROL CONTROL
71