Table of Contents
Advertisement
•
If the call is in the secure mode and the transceiver
does not have the proper encryption key,
"KEYFAIL" is displayed and the call must be
made in the clear mode by pressing the Clear/
Secure option key or selecting that menu param-
eter (if strapped to switchable). Otherwise, load
the correct key.
4. When the call is finished or if it is not answered, end
it by pressing the Private Call option key or the F1
(Exit) key.
6.5.4 RECEIVING A PRIVATE CALL (ALL
TYPES)
1. When a private call is received, "CALL RCVD" is
displayed and the call tone sounds once.
2. To answer the call, press the Private Call option key
or select that menu parameter and then press the
PTT switch and begin speaking. The unit ID of the
calling mobile is displayed. More information
follows:
•
If the PTT switch is pressed before the Private Call
option key, the call is transmitted as a group call.
•
If private calls are not permitted (the Private Call
option key/menu parameter is not programmed),
press the Call Response option key or select that
menu parameter to answer the call.
•
The call must be answered within 20 seconds or it
is automatically terminated.
•
If the system is busy when a response is made,
"BUSY" is displayed and the busy tone sounds.
6.6 TELEPHONE CALLS
NOTE: Telephone calls are currently not available in
the P25 trunked mode or any secure mode.
6.6.1 GENERAL
The telephone call feature allows telephone calls
to be placed and received over the public telephone
system using your transceiver. Telephone calls are
programmed to operate in one of the following modes:
SMARTNET/SMARTZONE/P25 TRUNKED FEATURES
•
Disabled
•
Answer-only capability
•
List only - Telephone numbers can be selected
from a preprogrammed list only (direct entry using
the keypad is not allowed)
•
Unlimited - Telephone numbers can be selected
from a list and also dialed directly entered using
the keypad.
Both limited and DTMF keypad models can place
telephone calls by recalling the telephone number
from a preprogrammed list as just described. However,
only DTMF keypad models can directly dial telephone
numbers using the keypad.
6.6.2 PLACING A TELEPHONE CALL
Recalling From List
1. Momentarily press the Phone option key or select
that menu parameter. The alias of the last called tele-
phone number is displayed. The interconnect call
mode is indicated by
2. If required, press the Up/Down switch to display the
desired number. The alias of each number is
displayed.
3. Press and release the PTT switch and "DIALING" is
displayed. Events that may occur are as follows:
(Proceed to the bulleted list which follows Item 3 in
the next section for events that may occur next.)
Direct Entry Using DTMF Keypad
1. Press and hold the Phone option key until a tone
sounds (approximately 1 second). The alias of the
last called telephone number is displayed if it is in
the phone number list. Otherwise, the last eight
digits of the last called telephone number are
displayed. The interconnect call mode is indicated
by
in the display.
2. Enter the telephone number using the 0-9,
keys. To enter a pause (indicated by "P"), press
and then #. To erase the last digit, press the F1 key.
The number scrolls to the left in the display so that
the eight right-most digits are always displayed.
Numbers up to sixteen digits (including pauses) can
39
in the display.
*
, and #
*
Advertisement
Table of Contents
