Placing A Standard Private Conversation Call - E.F. Johnson 5100 SERIES Operating Manual

3. Press the PTT switch to initiate the call. If the
entered number is valid, the display indicates the
alias of the ID if it matches an ID in the call list.
Otherwise, the ID you entered continues to be
displayed.
Events that may then occur are as follows:
•
If the mobile being called is on the air, "WAIT" is
displayed and ringing is heard until the called
party answers or for 20 seconds, whichever occurs
first. Pressing the PTT switch or an option key
stops the ringing but not the call. When the call is
answered, the voice of the called party is heard.
•
If the called mobile does not answer within 20
seconds, a continuous tone sounds and "NO ANS"
is displayed.
•
If the called mobile is not on the air, a continuous
tone sounds instead of the ringing tone and "NO
ACK" is displayed.
•
If the busy tone sounds and "BUSY" is displayed,
the called mobile has answered the call but the
system is busy. When the system is no longer busy,
the call back tone sounds.
•
If your transceiver or the called transceiver is
inhibited or not programmed to make this type of
call or for the requested secure mode, "Rspns
Only" is displayed and an alert tone sounds.
•
If your transceiver does not have the proper
encryption key, "KEYFAIL" is displayed and the
call must be made in the clear mode by pressing
the Clear/Secure option key (if strapped to switch-
able). Otherwise, load the correct key.
4. When the call is finished or is not answered, end it
by pressing the Private Call option key or the F1
(Exit) key.
6.5.3 PLACING A STANDARD PRIVATE
CONVERSATION CALL
Recalling From List
1. Momentarily press the Private Call option key or
select that menu parameter. The alias of the last
SMARTNET/SMARTZONE/P25 TRUNKED FEATURES
called mobile is displayed, and the private call mode
is indicated by
2. If required, select another mobile by pressing the
Up/Down switch until the alias of the desired
mobile is displayed.
3. Press the PTT switch or the F2 key to initiate the
call.
(Proceed to the bulleted list which follows Item 3 in
the next section for events that may occur next.)
Direct Entry Using DTMF Keypad
1. Press and hold the Private Call option key until a
tone sounds (approximately 1 second). The last ID
called is displayed, and the private call mode is indi-
cated by in the display.
2. Using the 0-9 keys, dial the ID of the mobile you are
calling (all six digits). To erase the last digit, press
the Down key, and to cancel the call, press the
Private Call Option key again.
3. Press the PTT switch to initiate the call. If the
entered number is valid, the display indicates the
alias of the ID if it matches an ID in the call list.
Otherwise, the ID you entered continues to be
displayed.
Events that may then occur are as follows:
•
The called party answers the call.
•
The called party does not answer. Press the
Private Call option key or F1 (Exit) to end the
call.
•
If the selected mobile ID is not valid, "INVALID
ID" is displayed and an alert tone sounds.
•
If the radio system is busy, four low tones sound
and "BUSY" is displayed. When the system is no
longer busy, the call back tone (four beeps) is
heard and the channel is automatically acquired.
Press the PTT switch to continue the call.
38
in the display.