JVC KD-LH1150 Service Manual page 5

KD-LH1150,KD-LH1100
2.1.5 Removing the rear bracket
(See Fig.8)
• Prior to performing the following procedures, remove the front
panel assembly, front chassis assembly, heat sink and bottom
cover.
(1) Remove the three screws E, three screws F and three
screws G on the back side of the main body.
(2) Remove the rear bracket.
Reference:
During reassembly, before fixing the rear bracket onto the
main body, insert the subwoofer cable into the slot. (KD-
LH1150 only)
2.1.6 Removing the main board
(See Fig.9)
• Prior to performing the following procedures, remove the front
panel assembly, front chassis assembly, heat sink, bottom
cover and rear bracket.
(1) Remove the two screws H attaching the main board.
(2) Disconnect the connector CN601 and remove the main
board in an upward direction.
2.1.7 Removing the CD mechanism assembly
(See Fig. 10)
• Prior to performing the following procedures, remove the front
panel assembly, front chassis assembly, heat sink, bottom
cover, rear bracket and main board.
(1) Remove the three screws J attaching the CD mechanism
assembly.
1-6 (No.49817)
G
F
Rear bracket
E
Insert Subwoofer cable
into the slot. (KD-LH1150 only)
Fig.8
CN601
H
Fig.9
CD mechanism assembly
Fig.10
F G
E
Main board
H
J
Top chassis
J