Busy Status; Automatically Setup Room Number; Alarm Guide; Room Number Confliction Alarm - Kenwei E705FC Instructions Manual

Operation

13.Busy Status

When one of the room stations is under talking or monitoring mode, others will enter into busy mode.
After finishing talking or monitoring, all of the units will go back to standby mode.
Note: When the room station is under busy mode, it cannot operate room number setup and system reset
Function.

14.Automatically Setup Room Number

A.Single Room Station
Reset the unit, then calls from door station. The room number will be automatically setup after ringing.
B.Two Room Stations
Reset the units, then calls from door station. The room numbers will be automatically setup after
ringing.
C.More Than Two Room Stations
Reset all the units, then connect the power supply of main unit and the extension unit which you need
to setup as No.2, then calls from door station. The room numbers will be automatically setup after
Ringing. After that, connect the power supply of the extension unit which you need to setup as No.3,
then calls from door station. The room numbers will be automatically setup after ringing. Do the same
operation for No.4 extension unit.
26

15.Alarm Guide

15.1 Room Number Confliction Alarm

When the system has more than two room station with a same room number, the unit will sound "DI"
at intervals. You need to reset the room number to avoid the alarm. If the alarm is still existed after
reset the room number, you need to restart the power supply.

15.2 Communication Trouble Alarm

If the unit sounds " " every 3s, it means there is communication trouble between room stations.
DI D I
Please check the wiring and make sure if the main unit is turned on. After resolving the trouble,
press or to monitor or talk with door station, the alarm will be automatically canceled.
Note: For the extension room station, you will only hear the sound when you operate the monitor or talk
function more than 6 times.
Operation
27