Advertisement
ADAS-500 Data Collection System
User's Manual
Section 3 Getting Started
Configuration Settings
The Configuration Settings Dialog allows you to select the settings
for the PC interface. To change the settings, click the Settings
button and the dialog will appear (Figure 6).
ATCO Ethernet Interface
The ATCO Ethernet Interface provides an interface to both the
encoder and UT devices through the single ethernet connection.
The Krautkramer USN-52 and USN-58 are supported.
IP Address*
This is the IP Address of the MCU-500. This setting should not be
changed unless there are more than one MCU-500 connected to the
network. The default setting is 192.168.1.200.
Encoder Port*
This is the port to use for TCP communication with the Encoder on
the MCU-500. The default setting is 26.
UT Port*
Figure 8 Configuration Settings
This is the port to use for TCP communication with the UT device on the MCU-500. The default setting is 23.
* Note: These settings should not be changed. Changing this setting without changing the setting on the MCU-500
to match will cause the communications to fail.
Gate Settings
When using the USN-58 you can select the gate to read on the device. The values are the three gates S1, S2 and S3.
The USN-52 does not support this feature.
Restore Defaults
Clicking this button will set all the interface values back to their initial default settings.
Page 8
Revision 1.0
Copyright © 2005-2009 ATCO. All Rights Reserved.
Advertisement
