Advertisement
ADAS-500 Data Collection System
Running the DCM
Once the software is installed and the system is connected as shown above, you are ready to run the DCM.
Note: You must have the entire system connected, the MCU-500 and USN-52/58 powered up
prior to running the DCM.
From the Start menu select Programs | ADAS-500 Data Collection Module | ADAS-500 DCM
If you do not find the Start menu entry, proceed to the previous section and run the installation as specified.
Otherwise, select the menu option (as shown above) and the main screen of the program should appear as shown
below.
Current Position
Current Thickness
Crawler Scan
Direction Indicator
Figure 2 DCM Main Screen
Copyright © 2005-2009 ATCO. All Rights Reserved.
Scan Position
Menu Bar
Controls
UT Connection
Status
Data Collection
Status
Scan Graph
Position (encoder)
Connection Status
Page 4
User's Manual
Section 3 Getting Started
Application
Status
Location Grid
Revision 1.0
Advertisement
