Advertisement
ADAS-500 Data Collection System
The Current Thickness displays the thickness that is coming from the UT Instrument Interface. If the current
thickness is not being displayed, the UT status shown in the Application Status area will likely be ERR. When this
happens, the error will be indicated at the bottom of the window in the Status Bar. Typically if an error occurs, the
UT device is either off or the cable is not connected.
Scan Specific Information
The scan information shown here displays the
Data Increment
Scan Mode
Locations
Scan Graph
The Scan Graph displays the data graphically with the position on the Y axis and the thickness values on the X axis.
Location Grid
The location grid displays the locations stored in the scan.
Pos
Tk
Scan Position Controls
Set Position
Course Top
Course Bottom
Scan Dir
Copyright © 2005-2009 ATCO. All Rights Reserved.
The interval at which locations are stored in the scan. It can be changed by selecting the
Settings button on the Menu Bar.
This option is the mode selected for scanning. The options are low hold or point.
The number of locations currently in the scan
- the position of the location relative to the zero reference of the scan.
- the thickness value stored at that location
[F2] - Allows you to enter the current position.
Not used in this version
Not used in this version
[F5] - allows you to change the direction of the scan relative to the crawler. Positive
means that the crawler position increases when moving forward. Negative means that the
crawler position decreases when moving forward. The button indicates the current setting
(see below).
Page 6
User's Manual
Section 3 Getting Started
Revision 1.0
Advertisement
