Advertisement
ADAS-500 Data Collection Module
User's Manual
Appendix A Calibrating Encoders in the DCM
Step 3 - Move the crawler to the mark at the
end of the measurements distance. Do not click
Next until after you have aligned the crawler up
with the ending mark. Then click Next.
Step 4 - Test the calibration by moving the
crawler and checking the position displayed.
To accept the calibration, click Finish. If you
need to try again, just click the Previous button
or click on the appropriate tab at the top.
Revision 1.0
Page 2
Copyright © 2005-2009 ATCO. All Rights Reserved.
Advertisement
