Watching TV
Connecting the power cord
Connect the power cord after all component connections have been completed.
Plasma Display (bottom view)
Media Receiver (rear view)
A
OUT
ANT/CABLE 75Ω
L
• Use only the power cord provided.
• Do not use a power supply voltage other than that indicated (AC 120 V, 60 Hz) as this may cause fire or electric shock.
• For the Plasma Display System, a three-core power cord with a ground terminal is used for efficiency protection. Always
be sure to connect the power cord to a three-pronged outlet and make sure that the cord is properly grounded. If you use
a power source converter plug, use an outlet with a ground terminal and screw down the ground line.
A
• Always turn off the main power of Plasma Display and Media Receiver when connecting the power cords.
• Disconnect the power cord from the power outlet when the Plasma Display System is not going to be used for a long
period of time.
E-13
COMPONENT VIDEO
COMPONENT VIDEO
Y
P
B
P
R
Y
P
B
P
R
INPUT 3
RS-232C
B
INPUT 1
RGB INPUT
IN
OUT
CONTROL
INPUT 2
MONITOR OUTPUT
S-VIDEO
VIDEO
R-AUDIO-L
S-VIDEO
VIDEO
R-AUDIO-L
AC INLET
Power cord
SYSTEM
CABLE
(WHITE)
(GRAY)
AC INLET
AC INLET
Power cord